Standard [CURRENT]
Product information on this site:
Quick delivery via download or delivery service
All transactions are encrypted
This part of ISO 1938 specifies the most important metrological and design characteristics of plain limit gauges of linear size. This part of ISO 1938 defines the different types of plain limit gauges used to verify linear dimensional specifications associated with linear size. This part of ISO 1938 also defines the design characteristics and the metrological characteristics for these limit gauges as well as the new or wear limits state Maximum Permissible Limits (MPLs) for the new state or wear limits state for these metrological characteristics. In addition, this part of ISO 1938 describes the use of limit gauges. It covers linear sizes up to 500 mm. This document (EN ISO 1938-1:2015) has been prepared by Technical Committee ISO/TC 213 "Dimensional and geometrical product specifications and verification" in collaboration with Technical Committee CEN/TC 290 "Dimensional and geometrical product specification and verification", the secretariat of which is held by AFNOR (France). The German committee responsible for this document is NA 152-03-02-07 UA "Längenprüftechnik außer Koordinaten-, Form- und Oberflächenmesstechnik sowie Gewindekenngrößen" ("Length checking practice except coordinate, form and surface measuring technology as well as characteristics of screw threads") at DIN Standards Committee Technical Fundamentals (NATG).
This document replaces DIN 7150-2 Berichtigung 1:2007-08 , DIN 7150-2:2007-02 .