DIN EN 61215-1-2:2017-10

This part of IEC 61215 lays down IEC requirements for the design qualification and type approval of terrestrial photovoltaic modules suitable for long-term operation in general open air climates, as defined in IEC 60721-2-1. This document is intended to apply to all thin-film CdTe based terrestrial flat plate modules. As such, it addresses special requirements for testing of this technology supplementing IEC 61215-1:2016 and IEC 61215-2:2016 requirements for testing. The object of this test sequence is to determine the electrical characteristics of the module and to show, as far as possible within reasonable constraints of cost and time, that the module is capable of withstanding prolonged exposure outdoors. This document specifies the changes to the test procedures and requirements according to IEC 61215-1:2016 and IEC 61215-2:2016 that are dependent on the PV technology. This document does not apply to modules used with concentrated sunlight although it may be utilized for low concentrator modules (1 to 3 suns). For low concentration modules, all tests are performed using the current, voltage and power levels expected at the design concentration. The responsible committee is DKE/K 373 "Photovoltaische Solarenergie-Systeme" ("Photovoltaic solar power systems") of the DKE (German Commission for Electrical, Electronic and Information Technologies) at DIN and VDE.