DIN EN 60684-3-282:2011-04

This standard is part of a standard series dealing with insulating sleeving for electrical purposes. The series "Flexible insulating sleeving" consists of three parts: - Part 1: Definitions and general requirements (IEC 60684-1); - Part 2: Methods of test (IEC 60684-2); - Part 3: Specifications for individual types of sleeving (IEC 60684-3). This part is one of the sheets which belong to Part 3: Sheet 282: Heat-shrinkable, polyolefin sleeving, stress control. This standard contains requirements for two types of non-flame retardant polyolefine sleevings with stress control and without internal coating, with a shrink ratio of 3:1. These sleevings are suitable for use at temperatures of up to 100 °C. - Type A: average wall thickness, inner diameter of up to 65,0 mm, typical value - Type B: thick wall thickness, inner diameter of up to 95,0 mm, typical value These types of sleevings are usually supplied in the colour black. These insulating sleevings are used as accessories for medium high voltage cable fittings and end closure fittings with stress control. As sleevings of this type comprise a considerably wide range of sizes and wall thicknesses, a guideline for the series of available sizes is given in Annex A, Tables 3 and 4. The actual size shall be agreed upon between user and manufacturer. Materials which conform to this standard meet established requirement levels. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this standard alone. These sleevings are intended for use as cable accessories for medium-voltage applications; their electrical performance shall therefore be tested as part of the assembly. Examples are described in HD 629 and IEC 60502. The responsible Committee is K 181 "Feste elektrische Isolierstoffe" (AK 181.0.5 "Isolierschläuche") ("Solid electrical insulating materials" (WG 181.0.5 "Insulating sleeving")) of the DKE (German Commission for Electrical, Electronic and Information Technologies) at DIN and VDE.