DIN EN 60384-14-2:2017-01

This blank detail specification forms the basis for a uniform procedure for a common International Safety Mark. It implements the approval schedule for safety tests, requires a declaration of design for parameters relevant to safety and indicates conformance tests to be conducted on every lot prior to its release and requalification tests depending on changes to the declared design. In comparison with IEC 60384-14-1 which provides quality conformance and safety tests, this specification is restricted to safety tests only. A blank detail specification is a supplementary document to the sectional specification and contains stipulations on the structure, arrangement and minimum content of detail specifications. A blank detail specification is a supplementary document to the sectional specification and contains requirements for style, layout and minimum content of detail specifications. Detail specifications not complying with these requirements may not be considered as being in accordance with IEC specifications, nor should they so be described. The normative Annex A contains the declaration of design, which is to be treated confidentially between the manufacturer and the certification body. The purpose of this declaration is to specify essential data and the basic structure of the capacitors for which approval is sought. The completed form shall be submitted to the certification body prior to the start of the approval tests; the manufacturer reserves the right to pass it on to third parties. Changes to the declaration of design are only permitted after written notification of the certification body. In such cases, the certification body decides on necessary steps. It may be necessary to repeat the entire certification test. The responsible committee is DKE/K 623 "Funk-Entstörmittel" ("Capacitors and resistors for electronic equipment") of the DKE (German Commission for Electrical, Electronic and Information Technologies) at DIN and VDE.