ASTM F 2247:2018

1.1 This test method covers the structural performance of metal doors and frames and their restraining hardware (such as latches and hinges) used as a blast resistant barrier. This method involves applying an equivalent static pressure based on the characteristics of the specified blast pressure and structural properties of the door panel design. 1.2 The static tests are valid for the unit size tested or for smaller units of analogous construction. Extrapolation of test results for units larger than the test specimen are not permitted. 1.3 This standard test method is not applicable to tests where the forces are created by explosive charges, forced air from a shock tube apparatus, or any other method used to generate a dynamic load. 1.4 The proper use of this method requires knowledge of the principles of pressure, deflection, and when applicable, strain gauge measurement. 1.5 Using this method, specimens may be tested to determine ultimate static capacity or tested to specific static test loads. 1.5.1 Procedure A shall be used when a load-deflection curve is not required and a single load is applied. 1.5.2 Procedure B shall be used when a load-deflection curve is required and a single or multiple loads are applied. 1.6 The values stated in SI units are to be regarded as the standard. The values provided in parentheses are for information only. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.