ASTM D 5966:2022

1.1 This engine lubricant test method is commonly referred to as the Roller Follower Wear Test. Its primary result, roller follower shaft wear in the hydraulic valve lifter assembly, has been correlated with vehicles used in stop-and-go delivery service prior to 1993. It is one of the test methods required to evaluate lubricants intended to satisfy the API CG-4 performance category. This test has also been referred to as the 6.2 L Test. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.2.1 Exceptions- Where there is no direct SI equivalent, such as pipe fittings, thermocouple diameters, and NPT screw threads. Also, roller follower wear is measured in mils. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 Table of Contents: Section Scope 1 Referenced Documents 2 Terminology 3 Summary of Test Method 4 Significance and Use 5 Reagents 7 Guidelines on Substitution 7.1 Apparatus 6 Preparation of Apparatus 8 New Engine Preparation 8.1 Installation of Auxiliary Systems and Miscellaneous Components 8.2 Test Procedure 9 Description of Test Segments and Organization of Test Procedure Sections 9.1 Engine Parts Replacement 9.2 Engine Starting Procedure 9.3 Normal Engine Shutdown Procedure 9.4 Emergency Shutdown Procedure 9.5 Unscheduled Shutdown and Downtime 9.6 New Engine Break-In 9.7 Pretest Procedure 9.8 Fifty-Hour Steady State Test 9.9 Periodic Measurements 9.10 Oil Sampling and Oil Addition Procedures 9.11 End of Test (EOT) Procedure 9.12 Calculation and Interpretation of Test Results 10 Environment of Parts Measurement Area 10.1 Roller Follower Shaft Wear Measurements 10.2 Oil Analysis 10.3 Assessment of Test Validity 10.4 Final Test Report 11 Reporting Calibration Test Results 11.1 Report Forms 11.2 Interim Non-Valid Calibration Test Summary 11.3 Severity Adjustments 11.4 Precision and Bias 12 Precision 12.1 Precision Estimate 12.2 Bias 12.3 Keywords 13 ANNEXES Guidelines for Test Part Substitution or Modification Annex A1 Guidelines for Units and Specification Formats Annex A2 Detailed Specifications of Apparatus Annex A3 Calibration Annex A4 Final Report Forms Annex A5 Illustrations ...

19.020, 75.100