ASTM D 4673:2023

1.1 This classification system covers only ABS materials and ABS alloys suitable for injection molding and extrusion. Some of these compositions are also suitable for compression molding. 1.2 This classification system and subsequent line callout (specification) are intended to provide a means of calling out plastic materials used in the fabrication of end items or parts. It is not intended for the selection of materials. Materials are to be selected by personnel with expertise in the plastics field where the economics, the environment to be encountered, the inherent properties of the materials, the part design, the part performance required, and the manufacturing process to be employed all enter into the selection. 1.3 The properties included in this classification system are those required to identify the compositions covered. Other requirements necessary to identify particular characteristics important to specialized applications are addressed by using the suffixes given in Section 5 . 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.5 The following precautionary caveat pertains only to the test methods portion, Section 12 , of this classification system: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: This standard and ISO 19062 address the same subject matter, but differ in technical content. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

83.080.20