Standards Worldwide
Standards Worldwide
Phone +49 30 58885700-07

Standard [WITHDRAWN] Article is not orderable

ASTM A 765/A 765M:2007

Standard Specification for Carbon Steel and Low-Alloy Steel Pressure-Vessel-Component Forgings with Mandatory Toughness Requirements

German title
Schmiedestücke aus unlegiertem und niedriglegiertem Stahl für Druckkesselteile mit vorgeschriebenen Anforderungen an die Zähigkeit
Publication date
2007 reapproved: 2022
Original language
English
Pages
5
Publication date
2007 reapproved: 2022
Original language
English
Pages
5
DOI
https://dx.doi.org/10.1520/A0765_A0765M-07R22

Quick delivery via download or delivery service

Buy securely with a credit card or pay upon receipt of invoice

All transactions are encrypted

Short description
1.1 This specification covers heat-treated carbon steel and alloy steel forgings with mandatory toughness requirements. These forgings are intended for pressure vessels, feedwater heaters, and similar uses. 1.2 These forgings include tube sheets, covers, channel barrels, integral forged channels, rings, nozzles, flanges, and similar parts. 1.3 All grades are considered weldable under proper conditions. 1.4 The maximum thickness of forgings produced to this specification is limited only by the capacity of the selected grade to respond to any heat treatment specified and to meet the specified mechanical tests, including impact tests at the specified temperature. 1.5 Material supplied to this specification shall conform to the requirements of Specification A 788/A 788M, which outlines additional ordering information, manufacturing requirements, testing and retesting methods and procedures, marking, certification, product analysis variations, and additional supplementary requirements. 1.6 If the requirements of this specification are in conflict with the requirements of Specification A 788/A 788M, the requirements of this specification shall prevail. 1.7 The values stated in either inch-pound units or SI [metric] units are to be regarded separately as the standard; within the text and tables, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.8 Unless the order specifies the applicable "M" specification designation, the material shall be furnished to the inch-pound units.
ICS
77.140.30
DOI
https://dx.doi.org/10.1520/A0765_A0765M-07R22
Replacement amendments

This document has been replaced by: ASTM A 765/A 765M:2024 .

Loading recommended items...
Loading recommended items...
Loading recommended items...
Loading recommended items...